Fits

Furnace Inducer Motor Fits ICP Heil Tempstar 1011409 HQ1011409FA 1011412 HQ1011412FA

(3 reviews) Write a Review
Shipping:
Calculated at Checkout
$256.99
Frequently bought together:

Description

This is a BRAND NEW FASCO Furnace Inducer Motor / Exhaust Motor. It is deisgned to work with ICP/Heil/Tempstar/Comfortmaker/Kenmore/Arcoaire/Synder General Furnaces. This is a direct replacement part for the part #s below. Motor is 115 volt. Thanks for looking and good luck!
Function:
An inducer motor is designed to expel the exhaust gas from the furnace. Older inefficient furnaces allowed the flue gas to escape the unit with virtually no resistance. Newer high efficient furnace heat exchangers are so restrictive that the flue gases cannot exit the furnace though €œnatural draft€. Therefore, the inducer is required to pull the flue gases through the heat exchanger. The inducer motor is usually the first thing that starts up when your furnace calls for heat.
Replaces Old Part #s:
1011409 HQ1011409FA 1011412 HQ1011412FA
Repair Difficulty Level:
difficulty graph
Partial List of Units that Use This Item:
Hit Ctrl+F and enter your model number for a quick search!
View AllClose

3 Reviews

  • 4
    Need to include Misc. parts, washers and pins

    Posted by Unknown on 24th Oct 2019 12:39

    The exhaust motor assembly is fine and easy to install however two misc. parts need to be included. They are the two exhaust blower washers. The old ones will crumble when you remove the old blower. Also needed to be included are the plastic pins that fasten the exhaust blower restrictor to the exhaust blower. These will also break/crumble when the restrictor is removed from the old unit. There are three pins but probably five should be included as chances are one or two will be damaged when inserting them as they fit very tight and bend easily. I obtained these parts from First Supply. The part numbers for packets of 10 and 12 respectively are: Washer, 1160252 and Pin 1149260. The cost for both parts is around $19.

  • 5
    Relatively easy to install, very good quality

    Posted by Steve on 16th Nov 2016 7:25

    The "ICP Heil Tempstar Furnace Inducer Motor" assembly was relatively easy to install. It fit very well, and included all the parts needed to complete the job. The new unit is much quieter than the old unit that was replaced due to water leaking out of it.

  • 5
    Fast Delivery!

    Posted by Unknown on 8th Jan 2016 12:56

    I was in search of this part for my furnace, which is 19 years old. My serviceman found the part through his parts distributor, but the distributor wanted $521 for it. I searched on line, and found the part through NA HVAC for $199. I received it 2 days later. My serviceman now says he will use the NA HVAC website to look for parts for his customers to save them money on their repairs.

View AllClose